AES 7170 Manuale Utente Scaricare il pdf (Pagina 10)

40-7705I-UM Page 10 Rev 4 March 16, 2007

Figure 3-2

3.1 Front Panel:

The front panel has the user display and controls. Figure 3-1 shows a view of the

front panel.

Tactile Response Sounder LCD Display Power Button Status Panel Alert Panel

Figure 3-1

3.1.1 LCD Display: The LCD is a 4-line display with 20 characters per line. It

shows messages for the 7705i. Use this in conjunction with the Alert panel to

interpret and acknowledge messages. There is also a tactile response sounder to

provide audible confirmation of a successful button activation.

In most modes of operation, the top line will be constant and usually displays the

LCD firmware version number and

AES copyright. Example:

Other lines will be used to display messages generated by the server. Refer to

Appendix B for a detailed explanation of server-generated messages displayed on

the LCD.

3.1.2 Power Button is used to turn On/Off and Reset the computer motherboard

integral to the MultiNet Receiver. Push to start up a

downed unit. Press and hold for 10 seconds to perform

an emergency shutdown (Not recommended for non-

emergencies).

3.1.3 Status Panel: Contains LEDs that indicate fault

conditions as described below: See Figure 3-2.

When any of the Status LEDs are activated to reflect a

failure, the LED on the Alert panel will also be

activated, causing the Alert Sounder to activate.

Pressing SILENCE will momentarily silence the Alert

Sounder for 30 seconds until message is cleared.

Pressing ACKNOWLEDGE will clear the Alert LED.

The status LED will not be “cleared” until the failure

has been corrected.

• Receiver: Red Led - Indicates a hardware or system fault in the server.

These faults will include Printer Offline and LCD display faults.

• CPU: Red Led - Indicates that the CPU or internal processor has

performed a reset either manually initiated or automatically by the internal

watchdog circuit. Pressing the Acknowledge button turns off this LED.

• Ethernet: Red Led - Indicates a fault condition with the Ethernet

connection as detected by a missing check-in from a 7170 IP-Link

Transceiver.

DATE:

TO:

FROM:

RE:

06 AES

Alert Sounde

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 110 111

Commenti su questo manuale

Nessun commento

AES 7170 Manuale Utente Pagina 10

Commenti su questo manuale